Top 7 Dishwasher Maifold Probe

Power Supply to Activate Electronic Components, Power and Ground Feed Tester, High Impedance Circuit Tester with Digital Volt Meter and Diagnostic Tester Modes with Complete Lead Set and Adapters to Fit, to Extend and to Reach for Unsurpassed Connectivity.

The Power Probe IV Diagnostic electronic circuit and component tester supplies battery power and ground. Featuring AC/DC Voltmeter, Ohmeter, Frequency, Pulsewidth (Positive and Negative) and additional diagnostic modes: Fuel Injector Tester, PCM/ECM Driver Tester and ECT2000 Signal tracer.

The Power Probe III Circuit tester (Red) with the ability to supply Power or Ground with an indicator tone and bright-white LED headlamps. Features Digital Voltmeter, Min/Max, Audible Circuit Monitoring, 4mm Standard Banana Jack and Auxiliary Ground for component testing. Works with 12 – 24 VDC Systems.

Add Water Sensors XS-01 to FloodStop System to Increase Coverage Floodstop water sensors XS-01 add protection to FloodStop systems for a single appliance. Note: not compatible with Whole House Floodstop Systems. Moisture sensors connect with primary water leak sensor to increase water damage protection for any Flood Stop Automatic Water Valve Shut-Off Devices with Water Alarm made from 2007 to present. Use Flood Stop Systems with Full-Port Motorized Ball Valves for washing machines, hot water heaters, dishwashers, ice makers, water dispensing refrigerators and more. Flat water leak sensor is 1.25 inches by 7.5 inches. Sensor lead is 3 feet long. Water moisture sensors connect in a “train” to increase area of coverage for flood protection for water appliances with individual FloodStop water alarm protection. NOTES: Quantity pricing is available on this item.

Creates a 1/8″ bead, 100′ long. 10 oz tube for caulk guns. Top quality food safe adhesive. 650F resistance. Quick ship

<1>Alarm handling: When it is found that the alarm is caused by water leakage or overflow, the following measures should be taken at this time:

1. Please close the water source valve immediately.

2. Carry out drainage and maintenance of pipelines to avoid economic loss or waste of water resources caused by accumulated or leaking water

<2>specification:

????Dimensions: 2.2 x 3×0.9 inches / 5.5x 7.1×2.2 cm

????Cable length: 44 inches / 1.2 m

????Battery: IN07A

???? Working voltage: DC9V

????Alarm current: less than 80mA

????Working temperature: 0-60 degrees

????Material: high quality ABS plastic

????Alarm decibel: 120dB

????Product weight: 0.1153 kg

<3>Backage includes:

???? 1x leak detection alarm

???? 1x battery

???? 2x screws

<4>Installation Note:

???? 1. Install the sensor in areas that are prone to leaks and water.

???? 2. Do not install the detector in a place where the sound is difficult to emit, such as in a cabinet.

???? 3. Do not install the detector in a place where there is rain, oil smoke, or water vapor.

???? 4. Do not install the detector in a place where the water has been submerged

???? 5. Please replace the battery regularly.

<5>Note: Precautions

???? When the detector detects water, if the detector is still in an alarm state after draining the accumulated water, it may be that there is residual water in or on the surface of the probe. This is to dry the residual water on the surface with a towel. See if the detector recovers; if it is still in the alarm state, shake the sensor several times, shake out the remaining water inside, and then use a towel to dry the surface of the sensor.