Top 10 Laundry Pump Lta

LTA-1-ABC Hartell Direct Mount Sink, Automatic Laundry Tray Pump with 8′ Cord and Plug

Intended for permanent installation, this laundry tub pump is designed for a maximum lift of 10-feet to handle normal waste water from domestic washing machines, bar sinks and all waste water not containing solids.

1/3 hp, automatic laundry tub pump, automatic switch starts motor when water enters in the pump body, mounts directly to tail piece, union, check valve & discharge valve included, no trap or inlet piping required, no vent connection required, thermal & overload protection, fits under wet bars, kitchenettes, vanities & utility sinks, maximum water temperature 140&degree. Fahrenheit.

Product Description

1/3 HP Utility Sink Sump Pump.

From the Manufacturer

1/3 HP Utility Sink Sump Pump.

Power to Protect: Effectively remove all waste-water not containing solids with the strong pumping action of this utility sink pump. The Mastercraft MAXIMUM 1/3 HP Laundry Tub Pump pumps up to 1400 gallons per hour and lifts water up to 10 feet to efficiently remove excess water before it can cause damage. In addition to laundry tubs, it is ideal for use with vanities, wet bars, kitchenettes and utility sinks. Permanent Installation: Prevent potential flooding in the laundry room with this dependable laundry tub drain pump. A self-contained unit, the pump mounts directly to the tub’s tail piece and is intended for permanent installation. No added venting connection, trap or inlet piping is required. Solid and Safe Construction: This rugged pump handles excess water easily and safely, whether it’s in the laundry room or for use as a kitchen sink pump. Its durable Noryl pump body is corrosion and water resistant. The motor features built-in automatic thermal and overload protection to prevent overheating and shuts the pump off if it exceeds safe levels. Sturdy and reliable, this laundry tub pump will keep your home dry and free from water damage. Connections Included: With the Mastercraft MAXIMUM 1/3 HP Laundry Tub installation is easy. The union and the check valves are included for quick and easy hook up and installation without the need to obtain extra parts. Use it as a laundry tub pump, a sink pump for basements, a kitchen sink pump, or wherever you need powerful and effective household pump.

The SANICONDENS is a small pump that may be used to pump condensate from condensing boilers, HVAC system, water heater systems, etc. The SANICONDENS will pump condensate water up to 15 feet in height and/or 150 feet away from a soil stack. Condensate water has the potential to cause property damage or even create health hazards that can affect indoor air quality. Many times, the condensate is not able to drain through gravity to an existing drain line. This is the reason a condensate pump is essential to many residential and commercial applications. The inside of the SANICONDENS comprises of a float mechanism, which starts and stops the unit, and the motor, which drives the pump. When the water enters the SANICONDENS, it activates the float mechanism, which in turn starts the motor. The motor is sealed for life in an oil filled enclosure. A spindle/shaft drives the impeller and therefore the moving parts are kept to an absolute minimum. Water enters the chamber and is pumped away into the sanitary sewer. The unit pumps the effluent upward to 15 feet and/or 150 feet horizontally (with gravity fall). Once the water is discharged and the water level in the container goes down, the float deactivates the unit until water enters the unit again. A normal operating cycle for the SANICONDENS can be as short as 2 – 10 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal. The discharge connection on the top of the unit comes equipped with a non-return valve, which prevents back flow into the unit. It is also highly recommended for the condensate pump to be connected to a Ground Fault Interrupter (GFI) circuit. The small, powerful pumping unit can be floor or wall mounted. It comes with an auxiliary external overflow switch that will shut down the appliance or alert the consumer in the event of overflow. It also includes all necessary hardware for ease of installation; 20 Ft of vinyl tubing, inlet adapter, discharge adapter

Product description

WRSC-6 Hz / Volts / Cord: 60 Hz / 115 Volts / 8′ Cord Features: -Completely assembled and ready to be installed.-Intermittent Liquid Temp. up to 125 F.-Epoxy coated cast iron housing.-Polycarbonate Cover.-Polypropylene Volute.-Nylon Impeller.-Carbon/Ceramic Shaft Seal.-Upper and lower bearings.-Automatic Operation.-Diaphragm switch Activator.-Switch on – 4-7” / Switch off – 1-3”.-HP: 1/3.-Hz: 50/60 or 60.-Tank Size: 3.5 Gallons.-GPM at 5′ of Head: 45′.-Maximum Head at 18′.-FNPT Top Vent Port: 2”.-Top Discharge Port: 1.5”.-Side Discharge Port: 1.5”.

From the Manufacturer

WRS Series, a convenient smaller sized tank and pump combo, is ideal for impractical gravity drainage areas such as under sinks and laundry trays. Includes: tank and pump with 8-Feet power cord. 1/3 Horsepower, 46 GPM at 5-Feet head, 115 V, 60 Hz.

The BURCAM 300608Z submersible sump pump is designed for use in residential applications either in a new installation or to replace an existing upright or submersible sump pump. The pump is constructed of rugged cast iron and non-corrosive thermoplastic and the 1/3 HP, 115 V, 60 Hz oil-cooled motor includes automatic thermal and overload protection. It is ideal for frequent drainage and has a 1 ½” discharge with a reducer for 1 ¼” discharge pipe. The pump has a piggyback tethered float switch and can be used to evacuate water from a sump basin as small as 14” in diameter. The maximum head is 18 feet and the capacity is up to 3050 US GPH.

Ssf33sdp, 1-1/2 In. NPT discharge for easy installation and compliance with building codes. 5.2 gallon basin capacity.

1/3 HP, 115 V, 60 Hz automatic laundry tub pump. Designed for use in residential applications to handle waste water not containing solids. The pump mounts directly underneath the laundry tub. The automatic diaphragm switch starts the motor when water enters into the pump body. The motor has built-in thermal and overload protection and the pump body is made of corrosion-resistant thermoplastic for durability. A union to connect to the laundry tub and a check valve for the discharge are included with the product. Maximum lift of 10 feet. Pumps up to 1400 US GPH. Capacity: 1400 US GPH/2’; 1200 US GPH/4’; 1020 US GPH/6’; 800 US GPH/8’; 500 US GPH/10’.